Should i seal the broom finished concrete.
Broom finish concrete driveway ideas.
Remove the weatherstripping after 20 minutes.
The typical process for a broom finish is.
After the concrete surface has been broom finished the scoring is created using a wide concrete tool that creates a smooth surface on both sides of the score joint.
Strike off with a screed.
This must be done during the final finishing of the concrete.
There s some disagreement here.
One is you could grind or polish the surface which would remove the rough broom finish and smooth the surface of the concrete.
Yes it is a good idea to seal the broom finished concrete.
Wait for the bleed water to evaporate.
Wait 6 hours before walking on it.
This is a normal type of broom finish we do on a lot of patios pool decks sidewalks and driveways.
A concrete sealer could be applied with some grit additive to keep it from being too slippery when it gets wet.
This is because the sealer will protect the concrete from road salts stains mold etc.
Spread the resurfacer until it s between 1 8 and inch thick.
Concrete driveways pictures gallery the concrete network.
In many cases.
This texture is great for around pools or areas that recieve water.
For a slip resistant finish wait 5 minutes then sweep a nylon bristle concrete broom across it 90 degrees to the foot traffic.
In this video we will show you how we broom finish concrete slabs.
Although with low water cement ratio exterior concrete with the proper amount of air there might not be.
Once the concrete has been trowelled smooth a large thin broom is used to create a textured finish.
Window pane concrete finish scoring can be combined with wide tooling of the surface to create a window pane effect.